Voltage stabilizers for medical and laser equipment
Your laser, ultrasound or dental unit cost lakhs. Pakistan's supply swings from a low evening sag to a high-voltage spike when power returns. A VOLTEC servo motor stabilizer holds it at a steady 220V ±1%, boosting low voltage and cutting high voltage, on pure copper windings. Chughtai Labs and medical equipment importers already run on VOLTEC.
Choose your equipment
Each page shows what to protect, the right size and the questions clinics ask us.
Laser machines
Diode hair-removal lasers · IPL / SHR platforms · Nd:YAG and Q-switched / picosecond tattoo lasers
Ultrasound & X-ray
Ultrasound and colour Doppler machines · Digital / DR and CR X-ray systems · Dental X-ray and OPG units
Dental clinics
Dental chairs and delivery units · Air compressors and suction · Autoclaves and sterilizers
Labs & hospitals
Chemistry, haematology and immunoassay analysers · Centrifuges, incubators and water baths · Lab and vaccine refrigerators
IGBT & SCR (custom order)
Sensitive diagnostic and lab electronics · Laser platforms whose maker specifies solid-state protection · Equipment on very weak lines (IGBT works from 90V)
The danger most stabilizers miss: high voltage
Everyone plans for low voltage. But when the grid comes back after load-shedding, or the load on your transformer drops late at night, the line can jump to 260–280V — and that is what burns power boards. Some stabilizers only boost low voltage. Every Voltec servo stabilizer also brings high voltage back down to 220V, and its cutoff and time-delay restart keep the surge from ever reaching your machine. Ask any seller one question: what does it do at 270V?
Why clinics choose a Voltec servo motor stabilizer
What size do you need?
Machine rating in kVA (watts ÷ 0.8) + everything else on the same supply + 25%. Typical setups:
One analyser, ultrasound room or bench
One laser room — our most-ordered size for lasers
A full clinic, two machines or dental with OPG
Very weak line — works from 60V (single-phase)
Diagnostic centre or hospital wing
IGBT / SCR solid-state on order
Need solid-state? IGBT and SCR on custom order
For the most sensitive electronics, or a load that needs the fastest possible correction, we supply solid-state stabilizers on custom order. Tell us the machine and we quote the specification, price and lead time in writing.
Inverter (IGBT)
- 220V ±2% from a 90–310V input
- 0 ms rated response, pure sine (THD under 3%)
- No motor or brush — nothing to wear
SCR (thyristor)
- 220V ±5% from a 95–250V input
- About 20 ms response
- Lower-cost solid-state option
Not sure which you need? We'll tell you honestly — most clinic equipment runs best on a servo. IGBT & SCR custom order →
Four decades of power engineering in Lahore.





Clinics ask us.
Which stabilizer is best for medical equipment in Pakistan?
Does a Voltec stabilizer protect against high voltage?
What size stabilizer does my clinic need?
Can I order an IGBT or SCR stabilizer?
Do you cover MRI or CT?
Do you deliver outside Lahore?
Tell us the machine. We'll size the protection.
Send the machine model and your city on WhatsApp. Written recommendation and quote, 1-year warranty, nationwide delivery.
WhatsApp Voltec